Clements Custom Guns

Home

About Us

Ruger Revolvers

Sights

SA Handgun Packages

Misc & Conversion Options

Rifle Services

Notes From David

Ordering and Payment Info

Order Form

Links Page

Gun Pictures

How It's Made

Customers and their guns.

Ruger DA Revolvers

Items For Sale

I will list completed guns and other items of interest for sale on this page. Check back often as it will be changed regularly.
All parts are judged for condition by me in a conservative manner. I do not sell barrels with pitted bores or parts that are unserviceable unless this is made clear in advance. All descriptions are as accurate as I can make them. Be aware that most of the parts I sell are used and may exhibit finish wear. If you want them refinished, I will do so at an additional charge. Shipping of parts orders is usually done in 1-3 days. 


Listed below are a few items I currently have for sale. Updated 2-2-12.
 
1. Misc. factory barrels and cyls. to fit SA & DA Ruger and S&W revolvers and Marlin leverguns. Email me your needs.

2. 1-OM .357 Flattop rear sight assy. in good condition. $75 ppd.


Misc. items from around the shop:

1- Motorguide Pro Series 4300 foot control trolling motor, 43# thrust with 36" shaft, Motor is only a few years old, seen little use, and in excellent condition, plug and receptacle included, will work great on 14'-16' aluminum boat. $250
Several new takeoff stainless Old Army 7 1/2" barrels- $50 each
2- Old Army SS factory hammers   1-blue  $65 each
Several alloy OM XR3-Red frames $20 each 
1- Remington 700 takeoff barrel in .30-06, blue, with sights, 22" L, standard factory sporter contour, matte finish, excellent condition. $30   
2- S&W 4" M67 stainless .38 Special barrels, like new condition. $75 each
2- S&W M67 .38 Special cyls., Like new condition. $75 each
1- Big Loop factory lever for Winchester 94 Angle eject Wrangler .44 or .30-30. Excellent condition. $100
1- .44 Redhawk cyl. w/ extractor, blue- $75
All sorts of small takeoff parts for NM Blackhawks and Marlin leverguns- call or email with needs
10 boxes Federal Premium 7mm Weatherby 160 gr. Nosler Partition- $35/box or $300 takes them all with shipping included.
1- Douglas Premium .30 cal. CM barrel blank 1.25" dia. 1-10" twist, 28" long- $125
1- New Pac-Nor stainless super match grade barrel .30 cal., 1-12" twist, contour- Ruger 77 MKII standard Sporter, will be a drop in stock fit for guns in .243, .308, & 7mm-08. Unchambered and unthreaded. Maximum finished length 23". $250.
I will chamber and fit for $150 additional
2- USFA Bisley gripframe front strap only- blued,new takeoffs- $25 each
2- OM Ruger .357 factory hammers- some blue wear but notches are in good shape- $50 each
1- OM Single Six .22 factory hammer-good condition- $50
1- Ruger 77/44 rotary magazine, new condition- $15
3 sets Ruger 77 stainless med. height scope rings- excellent to new condition- $25/set
1 set Ruger stainless rings for Hunter model- both rings same height- $25
1- Power Custom halfcock kit for Ruger Blackhawk or Super Blackhawk, Previously installed in a gun, but no fitting was done, no installation instructions available- $35
1- Stainless cresent ejector rods for standard length ejector housings made in my shop, matt or polished finish- $35 each
1- Project gun barrel- stainless .44 cal. with perfect bore and exterior, Turned and polished at .755" diameter for a perfect fit on OM .357 guns. Barrel was made from a Super Redhawk barrel which sports deep groove rifling. Barrel has been threaded for the Ruger receiver thread and is 5 1/8" long with centers cut on both ends. Forcing cone and crown have not been cut. $40






It's time to clean out the grip box. To order, email me with the # of the grip(s) you want and I will verify availibility. All are from NM Blackhawk or Bisley guns unless noted and are the older grips as made for Ruger by Lett's. The last 3 pair are off current production guns and are the newer type. I will take payment by CC over the phone, check, cash, or paypal. Shipping is $5 total for as many as you want. If the grip screw is not pictured with the grips, you will not receive one.
Pricing:
1-8- This is the best grade. Like new to excellent condition- $20/pair
9-17- These are in good condition with scratches, medallion wear, or slight dings. All have sound wood and can be restored.- $15/pair
18-20- Newer production in like new to excellent condition- $15/pair
If pic is missing above #, grips have been sold. 

 
#1 ------------------------------- #11
#2 -------------------------------------------------#12
#3-------------------------------------------------#13
#4-------------------------------------------------#14
#5----------------------------------------------#15
#6---------------------------------------------#16
#7-------------------------------------------------------#17
 
#8---------------------------------------------------#18
#9------------------------------------------------------#19
#10 XR3 look to be rosewood--------------------------#20